Revox Re:source MK3 Manuel de service télécharger pdf (Page 10)

Kaleidescape

Re:source

Setup menu ~ COMPONENTS [Settings] ~ CONTROL

The serial interfaces can be configured in the sub-menu ~ CONTROL.

The following settings should be made for an error-free communication

with the Kaleidescape module:

RS232 interface

Baud Rate 57600 bit/s

Data Bits 8 bit

Parity Bits None

Stop Bits 1

Flow Control None

Music Player ID

As well as the serial interface setting, the Music Player’s Control Protocol

Device ID must also match up with the defined Device ID in the setup of

the Revox Kaleidescape module.

In the screen shown below, the number 3 was selected.

The permitted input range is 1 – 99. Make sure that no other Kaleidescape

components are using the same number. Also refer to the Chapter Setup

Kaleidescape Module, Section n Identification number.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 36 37

Pas de commentaire

Revox Re:source MK3 Manuel de service Page 10